LED panel lights as a new light source --led as the light source of indoor lighting, in the design highlights the beautiful simple design concept, the atmosphere of luxury momentum, with the beauty of people's eyes, unique design, through the light guide plate through The light, enough uniformity, soft light and bright and comfortable.
Led panel light from the border and the bottom plate, light guide plate and diffuser plate, lamp beads and patch, aluminum plate, power lamp basic components, LED appears to break the traditional light source design methods and ideas, Led panel lights through the light guide plate through Of the light, enough uniformity, LED Surface Panel Light soft light and bright and comfortable. Led panel lamp use is also very wide, has been replaced by the trend of the grille, the following small series to a brief introduction.
LED panel light is a high-end indoor lighting, the outer frame by the anodized aluminum alloy, the light source for the LED, the entire design simple and beautiful lighting, atmospheric luxury, both good lighting effects, but also bring people The feeling of beauty. LED panel lights unique design, LED Surface Panel Light light through the light transmittance of the light guide plate after the formation of a uniform flat light effect, illumination uniformity, light soft, comfortable and without losing the bright, can effectively alleviate eye fatigue. LED panel lights can also prevent radiation, will not stimulate pregnant women, the elderly, children's skin.
Led panel light use __led panel light accessories
1. Panel light aluminum frame:
Is the main channel of LED cooling, LED Surface Panel Light the appearance of simple and generous, you can use ZY0907, the use of mold stamping die low cost, processing costs are low; die-cast aluminum frame IP level can be higher, the surface texture is good, the overall appearance, but the early investment in mold costs Higher.
2.LED light source:
Often LED lamp beads use 3528, it was also used 3014 and 5050.3014 and 5050 low cost, light effect slightly worse, the key is its light guide network design difficult. LED Surface Panel Light 3528 luminous efficiency of high network point of good versatility.
3.LED light guide plate:
The side of the LED light through the network refraction of the light from the front evenly derived, light guide plate is the key to LED panel light quality control. Network design is not good, see the overall light effect is very poor, the general will appear on both sides of the dark side of the dark, or there is a light band into the light, or visible local dark areas, LED Surface Panel Light or appear different brightness inconsistencies.
4.LED Diffusion Board:
The light guide plate light evenly derived, but also play a role in fuzzy network. Diffuse plate generally use the acrylic 2.0 sheet or PC material, almost the PS material, the lower the cost of acrylic and light transmission than the PC slightly higher, acrylic brittle anti-aging performance is weak, PC price is slightly more expensive, but anti-aging performance Strong.
5. Reflective paper:
The light guide plate on the back of the remaining light reflected to improve the light efficiency, usually RW250.
6. Rear cover:
The main role is to seal the LED panel lights, LED Surface Panel Light generally with 1060 aluminum, but also play a little heat dissipation.
7. Drive power:
There are two kinds of LED drive power, one is the use of constant current power supply, this model is high efficiency, PF value of up to 0.95, cost-effective; second is the use of constant pressure with constant current power supply, stable performance, but low efficiency,
8. Install the pendant:
Hanging wire, mounting bracket, etc. for the installation of fixed parts.